J&K High Power Distribution Board (Comes with BEC VRM 5V-12V output)

4OZ copper poured, overload capacity is about 6S 120A, comes with low corrugation voltage regulator. It can power the brushless gimbal directly.
It comes with 10-20V adjustable voltage output module, the maximum power output is 36W 12V, output 3A 5V.

It comes with Voltage Stabilization ouput module, the maximum power output is 15W 5V, output 3A.

About the Distribution Board

(1)The main module of the distribution board

1. Main board
2. 10-20V adjustable voltage output module, the maximum power output: 36W 12V, output 3A
3. 3.5V voltage stabilization output module, the maximum power output: 15W 5V, output 3A

(2). How to install it

As shown in the picture, you need to solder the main board with the power module by contact pin comes with it. There is mark for where to install the module. And if you install the module to the wrong place, the pin hole could not match.

(3). Input and Output on the board

Mark 1 nd 2 on the picture can be the input end of the power (VIN/VOUNT is ¡°+¡± electrode, and GND is ¡°-¡± electrode)
3 is 5V voltage stabilization module output end (The position where the 5V marked is ¡°+¡± electrode, GND is ¡°-¡± electrode, it can output 4 route at the same time)
4 is 10-20V adjustable voltage output end (The position where the 5V marked is ¡°+¡± electrode, GND is ¡°-¡± electrode, it can output 4 route at the same time)
5 is the ouput end of the power. It need to connect with ESC or other electronic parts, there is ¡°+¡± and ¡°-¡± mark near every bonding pad, ¡°+¡± is ¡°+¡± electrode, ¡°-¡± is ¡°-¡± electrode.

Note: The LED on the main board need 5V power supply.

The Specification of the Distribution Board:
Installation hole: 45 x 45mm
Copper poured thickness: 4OZ
Power circuit overcurrent ability: 6S 120A
Output power of 5V module: 15W
10-20V adjustable module output power: 36W