From 9.11 to 9.25, buy the drone, Get one free 4S 1500mah Lipo Battery.
ARRIS X220 220mm FPV racig drone RTF is fully assemble and tuned, it is ready to fly. ARRIS X220 RTF comes with ARRIS X2205 2300kv high quality brushless motor,Flycolor Raptor S-Tower BHeli-S 2-4S 4-in-1 30A ESC + F3 + PDB + OSD board,5042 high efficiency propeller,5823S 5.8G 300mW 40CH mini video TX,Radiolink AT9 with R6DSM mini receiver and 4S 1500mah 50C lipo battery. Before leaving the factory, the RTF is tuned and tested by the technician.
The main feature of the ARRIS X220 is the "X" symmetrical design,light weight,simple structure,durable and agile.
Diagonal Wheelbase: 220mm
Flight Controller: F3 flight Controller
Frame Material: Pure Carbon Fiber
Radio System: Radolink AT9 with Receier
Camera: ARRIS XAT700M FPV camera
FPV TX: 5.8G 200mw 40CH
Antenna: 5.8G Antenna
Flying Time: About 12 minutes (hovering)
Battery: ARRIS 4S 1500mah 50C Lipo
(XT60 installed on upper plate in default)
The ARRIS X220 comes with the chamfered edge design on the arm, which gives the quad a sleek look.It comes with 4mm pure carbon fiber plate arm, make the frame super strong.The ARRIS X220 is made of pure carbon fiber with alloy pats, the weight is quite light.The structure of the X220 is simple, it is easy to maintain.
Flycolor Raptor S-Tower comes wih BLHei-S 4-in-1 ESC and F3,PDB and OSD. The ESC comes with EFM8BB21F16G MCU, support Dshot / Multishot / Oneshot,support high KV motor, can support at most 500k eRPM.Dshot is digital signal, anti-interference ability is stronger, and do not need throttle calibration.
The default firmware of the F3 is betaflight,it supports PPM, PWM and SBUS remote control / receiving mode. Built-in current meter, OSD directly display the real-time current without any additional connection.
With the tower on the ARRIS X220, the wires are tidy and concise. And it is more convenient to maintain in the future.
ARRIS X2205 V2 2300KV brsushless motor is high end brushless motor specially designed for high performance fpv racing drones.It adopts brand new M5 steel shaft, improving the structure strength. It had been upgraded to centrifugal fan design, optimizing the heat dissipation.It also adopts original Japan NSK bearing and N52 tile-shape magnets to ensure the power and quality of the motor.
ARRIS 5042 propeller--It has bigger windward area, well balance and strengthen root, and the efficiency is 10% higher than normal propeller.
ARRIS XAT700M HS1177 fpv mini camera is specially designed for FPV. It perfoms well in both bright and dark condition with 700TVL high quality image.The angle of the camera is adjustable on the ARRIS X220.
GoPro and Sports fpv camera can mount on the ARRIS X220, the mounting set is sold separately.You can check here. If you mount the GoPro or FPV camera on it, the XT60 plug for the battery need to install on the bottom plate.
ARRIS 5.8g 200mW 40-CH video TX pre-assembled.The The ARRIS TS5823L transmitter packs 200mW of ultra clean 5.8GHz power in a micro sized video/audio transmitter with LED display! The ARRIS TS5823L?is transmitting a full range of 40 channels and only weighs 6.5g.
ARRIS X220 has integrated with a remote controller battery warning buzzer, pilot can set the threshold (adjustable)according to CF parameter-adjustment software. In addition, you can also locate your racing drone through triggering the buzzer with the switch D on the transmitter.
Self-level mode�is the easiest to fly, because when you leave the stick at the centre and not controlling it, your drone just level itself and stays there. But Most advanced pilots would tell you they fly in Acro mode ALL THE TIME. Here are some of the advantages of Acro mode.
Manual mode�(Acro Mode) is useful for acrobatics such as flips or rolls, or FPV when smooth and fast control is desired. The picture below is what we set on our own Radiolink AT9 Radio.
Radiolink AT9S 10 Channel 2.4GHz Radio
Frequency: 2.4GHz ISM band (2400MHz to 2483.5MHz)
Modulation mode: QPSK
Channel bandwidth: 5.0 MHz and 250Kbps
Spread spectrum: DSSS&FHSS
Adjacent channel rejection: >38dbm
Transmitter power: less than 100mW (20dbm )
Operating current: 90mA@12V
Operating voltage: 7.4~18.0V
Control distance: More than 900 meters ground, 1500 meters air (the actual controldistance depends on the flying environment)
Channel: 10 channels,5-10 channels are customized
Compatible model: include all 120 degree and 90 degree swash-plate helicopter, all fix wings, glider and multi-rotor
Simulator model: under the simulator model the transmitter action turn off, change to power saving model
Screen: 2.8 inches 16 colorful screen, 240*320 pixels
Support receivers: R9DS(S-BUS&PWM), R10DS and R6DS
Size: AT9S- 183 x 100 x 193mm, R9DS- 41 x 23 x 14mm
High safety ARRIS 4S 1500mah Lipo Battery
ARRIS 4S 1500mAh 50C lipo battery is specially designed for FPV racer. The price of this battery is much higher than the similar batteries in the market, because we only sell top-quality batteries. As we all know, the low quality battery might have potential safety hazard, we will never tolerate such products.For ARRIS 4S 1500mah lipo battery, we have done UN38.3 test,1.2M Drop test,MDS report for it, for the test report, you can check�here.
1xARRIS X220 FPV Racing Quad Frame
4xARRIS X2205 2300KV V2 Brushless Motors (2CW+2CCW)
1xFlycolor Raptor S-Tower BHeli-S 2-4S 4-in-1 30A ESC + F3 + PDB + OSD
4xARRIS 5042 3-blade Propeller�
1xARRIS XAT700M FPV mini camera
1x5.8G 200mw 32CH FPV TX
1xFPV Transmitter Antenna
1xRadiolink AT9S Transmitter with R6DSM receiver�
1xARRIS 4S 1500mah Lipo Battery
Note: Battery Charger is sold separately.
Video by Sagnik Ghosh